Main > Main Forum
HELP! TV too tall!
sofakng:
Hmmm, this sounds a lot like the problem I had except mine was *slightly* different. My speaker support strips were sticking too far out the front of the cabinet...
Check here:
http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=21307;start=msg172490
How I solved my problem was by using a router with a standard bit. If you have screws near the spot you need to cut you'll need to do a little bit of work to get them out but thats probably you're best bet.
After routing and sanding the area where I "cut" my speaker support strip, you can't even tell there was ever anything there!
Hope this helps.
DanteBK:
No one probably remembers this old thread, but in case anyone did, this is how I finally resolved it:
First I went out and bought a slender handsaw that I figured I could use to saw off some wood and then later it would handy for sawing the marquee retainer and the t-molding. It was insanely useless for the wood sawing--I mean really, really useless. It would only sort of rub up against it like a horny old man, meaning well but not getting anywhere.
So I put it off. For the month of August I did pretty much nothing for my cab.
I want to paint it this weekend so first I decided I needed a resolution to this problem. So I took the foot off my jigsaw and just went to town on it.
Long story short, the TV fits now but the jigsaw blade snapped off during my last cut. The useless handsaw was able to crowbar the last chunk out.