| Main > Main Forum |
| drill before routing? |
| (1/1) |
| Scoobie:
While I'm waiting for my 1/16" 3-wing slot cutter to arrive, I'd like to drill all the holes and cut out the piece for the tb on my cp. Is there any reason why I should wait to drill/cut until after I have routed for the tmolding? Thanks! |
| SirPeale:
I don't think so. You're just going to be cutting the slot around it, after all. |
| Scoobie:
Sounds good to me! Off to drilling I go... Thanks! |
| patrickl:
if you route out a big hole close to the edge you might have problems keeping your router level when you are doing the slot for the t-molding. Drilling would be fine, but make sure you have enough space around that tb. |
| Scoobie:
Well, I drilled all the holes and cut out the tb. Once the router bit arrives, I'll let you know what happens. :) |
| Navigation |
| Message Index |