| Main > Main Forum |
| 1/16" Slot Cutting Bit from MCLS |
| << < (2/3) > >> |
| ThePaul:
I still haven't figured out how to assemble mine. What is the plastic spacer thing for? |
| RacerX:
I haven't started that adventure yet. But I look forward to the challenge. ;) |
| General Zod:
--- Quote from: Peale on July 15, 2004, 03:46:34 pm ---So I'm looking @ the bits here: http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html $16 for the complete assembly seems very reasonable, unless there's somewhere better? --- End quote --- Hey Peale, ;) I have that same bit that you're asking about. Also, a while back , I too had a difficult time putting it together. I have this link from when I asked about mine. http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=14402;start=msg112446#msg112446 It was another member ( Tilzs ) who helped me with assembly, so I hope the link helps you with yours. Mike |
| Effayy:
On the same topic, how deep does the cutter need to go to ensure the T-Molding is flush with the edge? Looking at the website in the link from the post at the top of this thread, I'm not sure whether #5341 or #7641 is what I'd need to buy. Actually, I'm not even sure what the difference in size means for the two of them... Hurray for woodworking newbies! Note: Edited the above to not reflect a need to "hurry for woodworking newbies" :) Typos in all the wrong places. bleh. - FA |
| RacerX:
--- Quote from: Effayy on July 16, 2004, 11:37:45 am ---On the same topic, how deep does the cutter need to go to ensure the T-Molding is flush with the edge? Looking at the website in the link from the post at the top of this thread, I'm not sure whether #5341 or #7641 is what I'd need to buy. Actually, I'm not even sure what the difference in size means for the two of them... Hurry for woodworking newbies! - FA --- End quote --- Cutting the slot 3/8" deep should suffice. |
| Navigation |
| Message Index |
| Next page |
| Previous page |