| Main > Main Forum |
| Router Bit Retard |
| << < (2/2) |
| Nannuu:
No worries. I've put new T-molding on old cabs and there were pretty loose, just run a bead of glue in there before you press it in. If it starts to pop up run some pieces of masking tape around the edge until it dries. |
| BigNIck:
"Subtract 1/32" from the t-molding channel insert width." ? Explain this image. 1/16 molding in a 3/32 slot? |
| JustMichael:
BigNIck, the 3/32" is from barb to barb on the t-molding. You want the barbs on the t-molding to dig into the slot so the barbs will hold the t-molding on. Therefore, you must make the slot smaller than the barb to barb dimension. |
| Navigation |
| Message Index |
| Previous page |