Main > Main Forum

Wiring Corn Door to I-PAC 2

Pages: << < (2/2)

MinerAl:

Just out of curiosity, how much corn do you put in a corn door? (the subject... nevermind)

Anyway, if you could take one of the switches off and get a good look at it it might be labeled (as suggested above).  

If you don't want to get a multimeter, you could always run the ground to one pole (call it pole X), and wire pole Y to the coin 1 terminal on the i-pac 2.  Then open a text editor on your computer and see if you get a 5 when you trip the wire trigger on your switch.  If not, try the other open pole (Z), and finally try Y and Z.  If none of them work, order new coin switches from Happs, which are labeled.  

It doesn't matter which pole on the switch is technically the "C" and which the "NO," as long as the circuit is normally open.



Buddabing:


--- Quote from: sc1103 on July 08, 2004, 08:19:06 pm ---k thanks ill try that...any suggestions on where to find a multimeter cheap?

--- End quote ---

Harbor Freight

Dartful Dodger:

Corn Door, that's funny.

 :)

alphasqorner:

 ;D ;D CORN DOOR  ;D ;D
hahahhahhaha

(I know, it's an innocent mistake, but it just sounds funny)

Pages: << < (2/2)

Go to full version