Main > Main Forum
p360 quick question
(1/1)
MasTequila:
Ok so I have looked at the instruction sheet about a million times and tried it as many ways as I can and I dont think I am putting it together right.  With the longer metal piece for a wood cp on I cant get the actuator at the bottom on with the e-ring. This must be an easy fix and I have just missed it so please help me out.

~Mas
monkeybomb:
It took me ten minutes to realize that I had to really press hard on the actuator because the spring is so strong.  I kept thinking that the groove was in the wrong place, but it wasn't.

In short, press hard.
MasTequila:
Ah. Thanks.
MasTequila:
What size screws should I use to mount and does it mount like the other happ joysticks or are the dimentions different, if they are does anyone know them offhand. Thanks in advance.
rdagger:
I've purchased several P360's and they all come with metal bushings that don't match the parts list.  The parts list describes 2 bushings (15-416400 .5" for wood & 12-408400 .156" for metal)  Instead they come with a single 5/8" bushing.  I think the manufacturer just assumes you will cut it to the proper length.  That's what I did.  You can compress the spring, but then it is rather difficult to insert and remove the "E" ring.  I just cut mine to 1/2" and it's much easier.

According to the instructions, if you have P360 questions you can call their support hotline:
800-230-P360 (M-F 8-5 MST)
Navigation
Message Index

Go to full version