| Main > Main Forum |
| Drilling through Formica laminate |
| (1/2) > >> |
| Jakedakat:
I am getting ready to mount my contols finally and had a couple questions. I am not the greatest carpenter ;) which is why I took a shortcut and bought a Slik Stik Quad blank. I am gonna be using carriage bolts to mount the joysticks, what I was wondering is should I drill from the top of the panel or the bottom? The panel is covered with a Formica laminate. Also any special kind of drill bit I should use? Any advice would be great thanks! Rob |
| SNAAAKE:
You drill from the TOP ! |
| JAMMA Guy:
You can drill from the bottom as long as you sandwich the laminate between another piece of wood ... this way is won't leave a rough hole when the drill bit breaks on through the laminate. |
| Hoagie_one:
sandwich, and clamp it |
| SideShow Rob:
Drill from the top. Use a 1/8" (3mm) wood drill bit for a pilot hole first, and then use the correct size wood drill bit for the hole proper. Take your time and go slow, and you should get excellent results. |
| Navigation |
| Message Index |
| Next page |