Main > Main Forum

arkanoid spinner pinout needed

Pages: (1/2) > >>

menace:

Does anyone have an arkanoid who could take a picture of the spinner guts for me?  I need to see the color of wire going to each lead to figure out which pin is which.  Thanks in advance

jerryjanis:

Here's a thread with a couple of picturs of some other optic boards.   I have been able to figure out some optic boards from similar pictures by tracing the circuitboard and seeing which ones go to the resistor:

http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=9837;start=msg73421#msg73421



menace:

cool!  thanks--I'll see if I can piece it together based on that.  I'll post pics back in that thread for a running spinner pinout page.

MrBond:

I have an Arkanoid running on my cab.  The pinout is as follows (left to right)
Green     Black     Red     Blue
X1        GND      5V       X2

As far as the placement, here's a cheesy picture (sorry my cam is not very good at closeups)

menace:

Thanks--I have that exact setup and it doesn't work so I suspect I have a spinner optics failure or the optipac isn't registering it (unlikley since the trackball works fine--but you never know)  Guess I'll try replacing the optics and see if that helps...

Pages: (1/2) > >>

Go to full version