| Main > Main Forum |
| arkanoid spinner pinout needed |
| (1/2) > >> |
| menace:
Does anyone have an arkanoid who could take a picture of the spinner guts for me? I need to see the color of wire going to each lead to figure out which pin is which. Thanks in advance |
| jerryjanis:
Here's a thread with a couple of picturs of some other optic boards. I have been able to figure out some optic boards from similar pictures by tracing the circuitboard and seeing which ones go to the resistor: http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=9837;start=msg73421#msg73421 |
| menace:
cool! thanks--I'll see if I can piece it together based on that. I'll post pics back in that thread for a running spinner pinout page. |
| MrBond:
I have an Arkanoid running on my cab. The pinout is as follows (left to right) Green Black Red Blue X1 GND 5V X2 As far as the placement, here's a cheesy picture (sorry my cam is not very good at closeups) |
| menace:
Thanks--I have that exact setup and it doesn't work so I suspect I have a spinner optics failure or the optipac isn't registering it (unlikley since the trackball works fine--but you never know) Guess I'll try replacing the optics and see if that helps... |
| Navigation |
| Message Index |
| Next page |