| Main > Main Forum |
| T-Stick users, how did you mount it? |
| (1/2) > >> |
| crashwg:
I'm almost ready to mount my t-stick and I'm not quite sure how I'm going to do it. I was considering using t-nuts on the top surface of the cp, but with plans of putting just an overlay "sticker" and no plexi or anything I would think that you'd have divots where the t-nuts are... |
| NoOne=NBA=:
I just screwed mine to the bottom of the CP. That worked for me with the bat tops, and the long balltops. The long balltops may come out a bit short for most people, with no routing. The short balltops are too short to bottom mount. |
| dabone:
I've got tstick pluses, top mounted on 5/8 particle board. Later, dabone |
| vputz:
I *was* going to use T-nuts, and then forgot to put them in before putting the top laminate on the CP (/sob). So I routed out about 1/4 inch of my panel (1/2" particleboard with 1/4" Pergo floor laminate on top) and just screwed them into the particleboard. I don't reef on the sticks too hard, but I haven't been excessively gentle either, and they have been holding up just fine. Used pretty fat #10 screws, as I recall. Doing it over--I'd do the T-nuts. If you're really concerned about the finish, you may consider a tiny bit of putty to smooth it over. -->VPutz |
| microwrx:
Bottom mount with carriage bolts. Routed 1/4" for T-Stick Plus' and 1/2" for T-Sticks to get them the same height. |
| Navigation |
| Message Index |
| Next page |