Main > Main Forum
How did you mount your Oscar Controls Mouse Hack?
(1/2) > >>
simplygriff:
I just got an Oscar Controls mouse hack for my Happ Trackball and am wondering how to mount the board so it's not flailing about inside my trackball panel.  Any suggestions?  There are some very small holes through the board I bet were used to hold it in place but I think finding screws long enough or thick enough to hold it in place would be pretty difficult.
delta88:
I zipped ties it and then zipped it to something else. could always wrap in in a static bag ir bubble wrap and tape it up as well.


sall good ;)
simplygriff:
There's an idea.  I hadn't thought of that.  

Any other solutions?
-G
rampy:
i didn't mount it IN the trackball... I mounted it outside with standoffs or something screwed into the control panel wood... I think.. it's been ages since i've looked under there.

rampy
NoOne=NBA=:
I mounted mine in a project box with the input cables coming out one side, and the USB cable coming out the other.
The actual mouse hack part is just thrown in loose, with cable restrictors on both cables, so that it doesn't get pulled on.
Navigation
Message Index
Next page

Go to full version