| Main > Main Forum |
| 'Mass' Cab Production Method? |
| << < (4/6) > >> |
| dirt:
zaphod, i ended up not going to my dads on sat. but i am going tomorrow for sure so i will get the info for you. I dropped 4 cylinders in my '53 ford coming back from a early morning car show on sat., so needless to say i spent the day wrenching on my car. i even missed the super auction because of it >:(. and as far as the router bit not lasting long, my dad has cut out 6 cabinets so far on the same bit. dirt |
| Wade:
The bit will probably last plenty long enough if you get a good carbide tipped bit. Wade |
| Santoro:
OK, so I took the plunge and tried it. I used a flush/trim bit and 3/4" plywood. I laid my prototype cab (no t-molding yet) on its side and clamped the 4x8 plywood onto it. I supported the overhanging plywood with a cardboard box. Just to be sure I didn't damage the prototype I adjusted the bit so that a hair-deep amount of plywood remained. I routed around the cab and it took about 2 minutes. It hesitated every now and then when it hit a knot in the plywood, but I managed OK. I sanded off the thin leftover plywood. Total effort - 5 minutes. The result was a beautifuly smooth template. (My previous circular saw/jigsaw effort took 45 minutes per side by the time I filed, sanded, etc - and the edge quality was inconsistient.) I see that it took its toll on the bit, I will probably only get a few more sides out of it, but that is only a $14 expense spread over a few cabs. This is unquestionably the way to go if you are building more than two cabs. Thanks guys! |
| spystyle:
Santoro, that's really groovy, Please post how many panels you are able to cut out before the bit starts smoking. Thanks, Craig |
| OSCAR:
Santoro - Yes, templates sure are the way to go, aren't they? I made a Pac side panel template a couple weeks ago and just got around to using it this past weekend. I made my template from 1/2" particle board because I had a left over piece just the right size. To prolong the life of the router bit, I first laid the template on the sheet of wood I was going to cut, and then traced around it with a Sharpie marker. Then I removed the template and rough cut around the traced line keeping within 1/4" or so. This way the router bit doesn't have to remove so much wood. I use a 3/4" diameter template bit with a 1/2" shank. I feel the larger shank bits help reduce bit vibration when cutting through 3/4" thick stock with a single pass. I've cut many templates out this way and I've never burnt up a router bit yet. I also lube the bearing on the bit between every other use or so which also keeps them running smooth. I have a particular template bit that I've used countless times over the past couple years and it still cuts like new, but I also keep the cutter face clean and the bearing lubricated, so that helps I'm sure. Here is a pic of the template screwed down to the 3/4" side panel: The below pics are after approx 10 hours of work, which also includes me figuring out how to securely mount a 26" TV tube without a frame into the cab. Using a router template is a very speedy way to make a professional looking cab without much effort. http://www.oscarcontrols.com/pacman/cab01.jpg http://www.oscarcontrols.com/pacman/cab02.jpg |
| Navigation |
| Message Index |
| Next page |
| Previous page |