Main > Main Forum
Any examples of installing monitor glass/plexi?
abrannan:
My cab (Reactor) already had a groove at the bottom of the monitor and an angle to the bottom of the marquee that hold the plexi in place.
crashwg:
Hmmm... I like the velcro idea. Do you think you'd be able to see the sticky side through the glass? I'm pretty sure I'm going to use smoked so that would probably help.
Stingray:
I've been digging through my site trying to find pics of how my glass mounts. This is the best I could come up with:
Here's a pic of my cab when I first got it, the glass rests on the two brackets that run along the inside above the monitor. In the back it slips into a groove, at the front it rests in a recess in the board you can see in front of the monitor.
After you put the glass in (actually it's plexi in this case), the control panel goes across the top of it in the front. Once it's clamped down the glass is securely held in by the groove in the back and the CP in the front.
BTW, these pics were taken some time ago. The cab has since been finshed with some nice artwork. ;D
-S
Santoro:
--- Quote from: crashwg on June 15, 2004, 11:13:00 am ---Hmmm... I like the velcro idea. Do you think you'd be able to see the sticky side through the glass? I'm pretty sure I'm going to use smoked so that would probably help.
--- End quote ---
I have smoked glass with a black surround painted onto the back.
See
http://www.mamenation.com/images/IMG_1475.JPG
RayB:
BLUEPRINT!!
(you painted over it?)