Main > Main Forum

Semigloss or gloss paint on a cab?

Pages: << < (2/2)

MonitorGuru:

- No latex
- SAND, PRIME and re-sand first!
- Build up a solid base color with FLAT or ULTRA FLAT black
- Spray 1 or at most 2 final coats with a Semi or full Gloss

(Building up a base with flat ensures you wont get runs by over spraying the glossy stuff that makes runs all too easily)

I actually avoid full gloss on everything.  I use Semi-Gloss on all metal control panels/coin doors/marquee holders.  I use SEMI-FLAT (rustoleum) on wood that is touched.  Just a *hint* of sheen and more cleanable than the chalkboard-like coating of flat or ultra-flat.  I use ultra-flat  (rustoleum) to spray the plywood surrounding a monitor/etc.. to prevent any side reflection of picture behind plexiglass, and just plain flat (other cheap brands) as the base for all other painting.


bionicbadger:


--- Quote from: OSCAR on June 08, 2004, 07:23:01 pm ---I've heard that Rustoleum semi-gloss black enamel is amost a perfect match for original Galaga cabs, and people have used that for touch-up with good results.  Definitely use an enamel paint, not latex.  You will get a much better finish.



--- End quote ---

I used the rustoleum type stuff for outdoor anti rust use or something.  It seems thicker than normal paint.  Very happy with it.   I would reccommend it.  It was semi-gloss I believe.
I only had time to put on one coat over the primer, but it turned out fantastic.
 

RayB:

Would any of you recommend painting by roller instead of spray?



AlexSledge:

I have sprayed the insides (work area) of cabs where there was a lot of black to lighten it up for working in medium/low light conditions. Since it's inside where it's generally seen by no one but myself might as well make life a little bit easier. Of course I use the cheap stuff for this.

Outside it's semi-gloss all the way unless it's an oddball (i.e. texture'd or something).

Pages: << < (2/2)

Go to full version