Main > Main Forum
T-Molding: All the way around, or just the front?
<< < (2/2)
BigBri:
I went all the way around except the bottom.  That was a mistake.  When I moved my cab against the wall, i just slid it on my concrete floor.  I kinda tore up the laminate.  If I had put t-molding on the bottom, maybe that would have prevented that.  I will be painting soon, so I have to get my bro over here to lift it away from the wall.  So take that into consideration, don't drag your cab on the floor.
sofakng:
Ok, I'm following the Project Arcade book and I believe that the two side panels will attach on top of a "cabinet bottom" piece.

So, to make the t-molding go all the way around, I would have to cut the slot around each side panel, and then continue the groove *through* that bottom piece (so it would go through both pieces to form a complete circle)

Understand what I mean?

Is that what I should do?
Navigation
Message Index
Previous page

Go to full version