| Main > Main Forum |
| what kind of dremel bit for t-molding |
| << < (3/3) |
| M3talhead:
Well, that's definitely a vagina..... |
| Barry Barcrest:
--- Quote from: Franco B on November 12, 2008, 04:17:24 am ---Back on subject.... If I was you I would buy a router and the propper slotting bit. It will cost you slightly more $$$ but routers really are a versatile tool. I only bought a cheap one but its paid for itself 1000 times over. --- End quote --- LOL This original thred is from 2002.... |
| Franco B:
Ha! I didnt even notice when the date of the previous post. What a random post to dig up to pr0n :spam: ??? Anyway, everyone buy a router! :) |
| EvilTwin:
Hey, I am slowly planning my first cabinet, which I will start building in a couple months. I'm slowly trying to gather the tools I'll need to do it; will this router do the job? http://www.homedepot.ca/webapp/wcs/stores/servlet/CatalogSearchResultView?D=943983&Ntt=943983&catalogId=&langId=-15&storeId=10051&Dx=mode+matchallpartial&Ntx=mode+matchall&recN=0&N=0&Ntk=P_PartNumber Or should I be looking at a 'plunge' router? I plan on putting a trackball in the control panel, if that matters. Then I guess I'll need a 1/16" slot cutting bit? |
| danny_galaga:
--- Quote from: M3talhead on November 12, 2008, 07:49:20 am ---Well, that's definitely a vagina..... --- End quote --- did you click the link to make sure ;D |
| Navigation |
| Message Index |
| Previous page |