| Main > Main Forum |
| Patching holes in metal CP |
| (1/1) |
| etumor:
I am looking at a metal control panel on eBay. It was used in a conversion cab, so they've drilled extra holes in it. I'm going to be removing those buttons, and putting a new overlay on it. Is there a good way to patch holes on a metal control panel? I know how you'd do it on a wood CP, but obviously that wouldn't work. And I don't want to just put the overlay on top of the empty holes, because one good poke would ruin the overlay. Suggestions? -Jeff "etumor" Allen |
| SirPeale:
http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=19242 http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=12361;start=msg96217#msg96217 |
| etumor:
Thanks. I actually did run a search, but I ran it on "patch a metal CP." I should have run it on "patch a metal control panel." -Jeff "etumor" Allen |
| mmmPeanutButter:
try Oscar's Centipede Restoration Page. |
| etumor:
--- Quote from: mmmPeanutButter on June 02, 2004, 06:45:09 pm ---try Oscar's Centipede Restoration Page. --- End quote --- Oscar is just freakin' amazing. There is nothing that guy can't do. |
| Navigation |
| Message Index |