| Main > Main Forum |
| covering CP with plastic laminate |
| << < (2/5) > >> |
| Veinman:
Does Lexan go through a table saw fine? |
| Joystick Jerk:
--- Quote from: Veinman on April 29, 2005, 07:04:42 pm ---Does Lexan go through a table saw fine? --- End quote --- Ergh.... I don't know, I've never seen anyone try that before. But I'm having visions of the Lexan shattering and sending razor-sharp shards flying through the air. You may be able to pull it off with a blade that has extremely fine teeth on it, but I still wouldn't trust it on a table-saw. |
| markrvp:
I don't know about Lexan in a table saw. I do know that they will cut fine with a BAND SAW. I plastic monitor bezel, will however cut nicely with a table saw with an MDF backer. |
| nostrebor:
--- Quote from: Veinman on April 29, 2005, 07:04:42 pm ---Does Lexan go through a table saw fine? --- End quote --- Yes. Like butter. High tooth count = better cut. Zero clearance throat plate helps with support of thin sheets. I strongly recommend carbide teeth for this, and a new or freshly sharpened blade is best. |
| MrSaLTy:
They do make saw blades especially intended for use with Acrylic/lexan etc. |
| Navigation |
| Message Index |
| Next page |
| Previous page |