Main > Main Forum
CP Wiring / Mounting Questions
<< < (2/2)
rescue161:

--- Quote from: rygar on May 28, 2004, 04:00:20 pm ---My next question is about joystick and trackball orientation. Does it matter how these are mounted to the panel since you can just configure them afterward? I didn't see a "this side up" mark on either.

--- End quote ---

The trackball should have an arrow with wording that says "Towards monitor".  Not all will say this, but the Happs ones do, at least the ones I've seen.  Other than that, it doesn't matter as you already know you can configure them later.

If it doesn't have an orientation marker, make sure that one of the spindles for the trackball is perpendicular and the other is parallel to the monitor.  You don't want the spindles at 45 degree angles to the monitor.
Navigation
Message Index
Previous page

Go to full version