Main > Main Forum
EZ way to put on t-molding??
Demon-Seed:
Hi
I got my tmolding for my control panel today. the panel is done and looks good, I am satisfied with it. I do not want try and cut the tmolding slot and screw it up.. any advise on how to do it right? I only have one shot.. its 3/4" inch black tmolding.
thanks
JIM
SirPeale:
Get some scrap board and practice cutting first!
spystyle:
.
Demon-Seed:
Hi
I seen that picture of the router you have...hmm its round and sits ontop of the wood.. the router I have is a handheld one...actually used to cut electrical outlets in try wall.. hmmm.... it can't use the top of the wood as a guide like the one in your pic :( any other solutions?? All I have is the control panel to t-mold
thx
JIM
REBIRTH:
Sounds like you have a handheld dremel type thing? I doubt you would be able to cut a t-molding slot very well with that at all. A normal router/router bit is self guiding, so it really does most of the work for you. You can route a slot around the entire panel in seconds. With a handheld dremel device I don't see how you could do it. Got any friends that you could borrow a router from?