Main > Main Forum

How much t-molding?

Pages: (1/2) > >>

rchadd:

how much t-molding is required for a pacman style cocktail cab?

would the 20' be enough?

Apollo:

More than enough you only need the T-molding to go around the flat top so unless your cocktail is going to be more than 5' square you will be fine.

rchadd:


--- Quote from: Apollo on May 24, 2004, 07:00:44 pm ---More than enough you only need the T-molding to go around the flat top so unless your cocktail is going to be more than 5' square you will be fine.

--- End quote ---

the midway cocktail cabs have t-moding around 2 sides and also the edges of the CP's

http://www.klov.com/game_detail.php?letter=&game_id=8784

Apollo:

OK well if you are building one of those it looks like you will need more than 20'. Remember to have a bit extra for stuff ups.

Blakey:

Can't you just measure the bits you want moulded on your plans and then order that distance plus a little safety buffer?

3 of the 6 main panels of my cab are shown below, I added up the routed perimeter in CAD and found it to be 11m (~36'). As t-molding.com only sells in 20' batches, 40' is just right.

Pages: (1/2) > >>

Go to full version