Main > Main Forum
Control Panel Shorts out? how do i fix?
<< < (5/5)
rsoandrew:
Try swapping two of the micro switches. ie move the left to up and vis versa but leave the same wiring.

If the problem moves you know that it's the switch or the wiring. There could be a break in the wire only allowing intermittent contact depending on position or even something as unusual as a small piece of something inside the switch preventing contact depending on the angle (I learned that lesson the hard way with a bad spark plug insulator that would move when I went uphill but ran fine on level ground  )
hyiu:
similar to rsoandrew ...

from the pics... it seems like the box is deep enough...
and with the edge already routed... it should not block the stick movement...

I think its a good idea to switch that particular microswitch out... and also change those 2 wires.... and retry...

and for stick it on....

I would say.... use panel clamps... and open a hole from the bottom so that you can reach in to unlatch....
Navigation
Message Index
Previous page

Go to full version