| Main > Main Forum |
| Button Wiring |
| (1/3) > >> |
| SalmonKing:
After a long break, I am getting back into this cabinet to finish it off. ;D I'm down to the last couple of bits & pieces, but one thing I'm unsure on is how to do the following. I have 4 buttons that need to act as Player 1's button 1 (as well as 4 buttons each for button 2 & 3). How do I go about wiring these to my I-Pac? I'm sure I don't chain them like the ground wires, so how can I get all 4 wires into the 1 point? Thanks, SalmonKing. |
| Apollo:
Just shove them all in there or best method is to use a terminal strip, 4 wires in, 1 wire out to the IPAC. |
| SalmonKing:
Thanks for the reply! I wasn't too keen on the 'shoving them all in there' method (which is what I was thinking of), so I'll have a look at the terminal strip option. ;D --- Quote from: Apollo on May 09, 2004, 10:07:42 pm ---Just shove them all in there or best method is to use a terminal strip, 4 wires in, 1 wire out to the IPAC. --- End quote --- |
| pointdablame:
I would vote for the terminal strip too. Although you might be able to shove them all in, the terminal strip would probably cause less headaches. And P.S. - thats a lot of buttons for P1B1... what's your CP gonna look like? |
| SalmonKing:
--- Quote from: pointdablame on May 09, 2004, 10:56:07 pm ---And P.S. - thats a lot of buttons for P1B1... what's your CP gonna look like? --- End quote --- This is it here : http://www.jaix.com.au/arcade/Img_0355.jpg So, buttons 1, 2 & 3 to the left & right of the trackball & spinner. I'm catering for both left & right handed players (I'm a lefty myself, as is the missus). |
| Navigation |
| Message Index |
| Next page |