| Main > Main Forum |
| tmolding alternative????? |
| << < (8/8) |
| MameMe:
Yea looks like pathdoc may be using something smaller, maybe 1/8"? Lets see what he says. |
| pathdoc2:
I'll have to check and see but I think its 1/4 inch but not set to the full depth. Does that make sense? I lower the bit just low enough to round the corners slightly. I hope this helps. Some of my machines are well over 2 years old now. The machine in this pic has been moved twice and all of the corners/edges are intact. Unfortunately this pic was take before I hand painted the sideart. |
| Navigation |
| Message Index |
| Previous page |