Main > Main Forum

How to remove small scrapes in t-molding? sanding?

Pages: (1/2) > >>

Demon-Seed:

Hi
My cabs t-molding has some minor scratches and instead of re doing it all I was wondering if I could sand them out with a light paper like 250? any suggestions?

thanks
JIM

menace:

a 400 grit wet sand followed by a buffing should do it--you could also just try the buffing by itself with some buffing compound.

Demon-Seed:

Hey
Ok bare with me.. ehehe... I can go buy sand paper at the store, no problem. But what is buffing compound? where would I find that? which section of a store? any certain kind I need to get? how is it applied.

thanks
JIM

Silly newbie I am!! ;D

Stingray:

You can get it at an auto parts store. Don't know how well this would work on plastic though.

T-molding is cheap enough. If the scratches bother you that bad it would be quicker and easier to just replace it.

-S

The Man:


--- Quote from: Demon-Seed on April 28, 2004, 11:18:58 am ---Hi
My cabs t-molding has some minor scratches and instead of re doing it all I was wondering if I could sand them out with a light paper like 250? any suggestions?

thanks
JIM

--- End quote ---

You could give Novus a try:

http://www.noscratch.com/novus/

TM

Pages: (1/2) > >>

Go to full version