Main > Main Forum
Installing an Over/Under Coin Door. Help please.
(1/1)
Piss Ant:
Hello all,
I seem to remember reading a couple of months back or so about installing a Happs Over/Under Coin door that someone posted a link or perhaps a pic on printing out a templete so one would know how large to cut the hole for the door.  I've searched for a while now & can't seem to find the thread. :'(  Can anyone help me out.  I'd like to install mine now, but not sure how to get the hole just the right size - That thread was - & now you guy's are my only hope.

"Help me BYOAC, you're my only hope" sorry but after typing the previous sentence I coundn't help but change it to reflect a famous movie line. ;)

Thanks,
Piss Ant
Santoro:
Fromm the Happ website:

Minwah:
I just turned mine over and traced it.  Then draw a line 1cm or so within that line and cut that out.  Then I had to jigsaw a few notches out to allow for the 'bumps' on the coin door :)
Piss Ant:
Excellent, That should do it.
Thanks Guys!
Navigation
Message Index

Go to full version