Main > Main Forum
Spinner/knob combo
NoOne=NBA=:
--- Quote from: andrewonawall on April 23, 2004, 11:17:49 pm ---I just hope that it won't look funny w/ the clearance needed to push down on the spinner.
--- End quote ---
I didn't even think of that.
The big flange at the bottom will be sitting 1/4-3/8" above the CP.
andrewonawall:
--- Quote from: NoOne=NBA= on April 24, 2004, 10:44:30 am ---
--- Quote from: andrewonawall on April 23, 2004, 11:17:49 pm ---I just hope that it won't look funny w/ the clearance needed to push down on the spinner.
--- End quote ---
I didn't even think of that.
The big flange at the bottom will be sitting 1/4-3/8" above the CP.
--- End quote ---
To see if it will look funny, I'm going to make a knob out of wood or clay and stick it on a small nail about that height. That way I'll know if I really want to do this, for it may just look terrible.