| Main > Main Forum |
| Joystick Hole Size |
| << < (2/2) |
| patrickl:
I just measured, but the stick standard only moves less than 20mm or about 3/4". The balltop only 14mm (9/16"). So, if you are planning to take the stick apart you can driller a much smaller hole. Especially if you are hiding those dust covers it will look a lot better when the hole is smaller. |
| Lance:
--- Quote from: patrickl on April 23, 2004, 11:43:54 am ---I just measured, but the stick standard only moves less than 20mm or about 3/4". The balltop only 14mm (9/16"). So, if you are planning to take the stick apart you can driller a much smaller hole. Especially if you are hiding those dust covers it will look a lot better when the hole is smaller. --- End quote --- Also the dust washer on the ball top is much smaller then the regular tstick handle. If you are using a ball top make sure you drill a smaller hole or else the washer will not cover it all. |
| Navigation |
| Message Index |
| Previous page |