Main > Main Forum

Joystick Hole Size

Pages: (1/2) > >>

SuperRabbit0:


I am reaching for the simplest question of all time but I'll be damned if I can find this here or on the Ultimarc site.

I am installing a T-Stick balltop in my panel.  What size hole do I drill for the joystick shaft?

TalkingOctopus:

A 1 1/8" hole should be fine.

exian:

I just made a test Control Panel and cut the hole using 1 1/8" Spade Bit using my Electric Drill. Its perfect for the shaft on the T-Stiks and its the same size hole for the Buttons so you don't have to swap Spade Bits, just keep on drilling.  ;)

brianoneill:

I was just about to ask a very similar question !
I was on happ controls website looking at the ultimate joy and wondering what size to drill.

Should it be 1 1/8" or 1.25" ?

Cheers.

patrickl:

The T-stick has a 33mm wide top (at least that's what it says in the diagram, mine is 31mm). If you drill a 1 1/8" hole you'll need to take the stick apart for mounting.

Pages: (1/2) > >>

Go to full version