| Main > Main Forum |
| Joystick Hole Size |
| (1/2) > >> |
| SuperRabbit0:
I am reaching for the simplest question of all time but I'll be damned if I can find this here or on the Ultimarc site. I am installing a T-Stick balltop in my panel. What size hole do I drill for the joystick shaft? |
| TalkingOctopus:
A 1 1/8" hole should be fine. |
| exian:
I just made a test Control Panel and cut the hole using 1 1/8" Spade Bit using my Electric Drill. Its perfect for the shaft on the T-Stiks and its the same size hole for the Buttons so you don't have to swap Spade Bits, just keep on drilling. ;) |
| brianoneill:
I was just about to ask a very similar question ! I was on happ controls website looking at the ultimate joy and wondering what size to drill. Should it be 1 1/8" or 1.25" ? Cheers. |
| patrickl:
The T-stick has a 33mm wide top (at least that's what it says in the diagram, mine is 31mm). If you drill a 1 1/8" hole you'll need to take the stick apart for mounting. |
| Navigation |
| Message Index |
| Next page |