Main > Main Forum
Adjusting mechs.......how?
Oldskool:
I have two American 25 cent coin mechs installed, and I was wondering how to adjust them to Canadian, and / or token.
It's a HAPP over/under door, and the mechs have Wells Gardner stickers on them.
There's adjustment screws, and a magnet right?
Is there a writeup somewhere that goes into detail?
T.I.A.
Edgedamage:
Step #1 toss them in the trash
step #2 PM me I have two that I will give to you.
Ken Layton:
Visit www.dameon.net/BBBB/cm.html for adjustment instructions. If the mechs have Wells-Gardner stickers on them then they are actually Coin Controls mechs.
mp2526:
--- Quote from: Edgedamage on April 18, 2004, 07:00:58 pm ---Step #1 toss them in the trash
step #2 PM me I have two that I will give to you.
--- End quote ---
Defiantely don't throw them in the trash, if they are the ones that came with the door I sold you, then they are brand new, and as Ken pointed out they are Coin Control mechs.
There should be a white nylon screw on the side that will adjust the size of the coin it will accept (within reason, but well within the differences between a US and Canadian quarter). I would first try adjusting that screw until coin is accepted. I don't have the mech in front of me right now, so I can't give you any detail beyond that, but I can take a look tonight to see if there are any other adjustment areas.
Lilwolf:
another option is take them apart... take the extra parts out... And create a pathway from the input to the coint part every time... (I used straws for the pathways... cut in 1/2 ( for the "U" that will cratle the coins as the run... the "0' of the straw made the coins sometime stick on the edges).
Anyway... at the end... ANY coin works... Very nice ot have a giant piggy bank.