| Main > Main Forum |
| screen plexi mounting ? |
| << < (4/7) > >> |
| steve_pss:
mine slides into a function button panel above my cp. it runs all the up and on the backside I have runners holding it tight. dont mind the lack of finish on the panel and sides, not done yet. |
| hulkster:
so did you route out the sides and bottom part to fit the plexi in? i'm thinking in my unique situation that im just going to have to route out slots and make sure i measure right and all that. |
| steve_pss:
actually i just set the table saw blade to the right depth (height) and ran the piece fenced to the width i need for the the plexi and happs surround. |
| hulkster:
i see. but i will have to curve my cut, so ill have to use a router |
| hulkster:
okay, i went to home depot to get some lexan, but there werent any pieces big enough for my cp. i mean, it was just like 2 inches short. anyway, i was looking around and saw "acrylic" and it was really nice material and looked strong, and what was better is that it was cut in a really big sheet. is this stuff easy to cut? does anyone else use this stuff??? |
| Navigation |
| Message Index |
| Next page |
| Previous page |