Main > Main Forum
screen plexi mounting ?
<< < (3/7) > >>
hulkster:
well i just want to make sure that its not visible that its being held up by anything.  like if i were to route out a slot for it to fit in, you wouldnt see anything holding it up, but i was just trying to find an easier way.
dmsuchy:
hulk, is your plexi gonna be clear or tinted? And how much bend will there be?
hulkster:
well i'll be getting lexan, and i dont think that comes tinted.  the bend is minimal at best.  um....if you took a piece of lexan and held it upright and then pulled down both ends 2 inches, thats about the bend of it so its not much.  
dmsuchy:
Yeah, if your gettin clear plastic you will see the velcro on the inside. I'm using "bronzed plexi" and it hides the fact that there is velcro on the other side of it. The bronzed plexi has an awesome effect, and you don't need a bezel. Your routing idea seems like a good idea, It's just going to be hard to route that curved line in unless you make a template for you router to follow.
hulkster:
well hopefully i can find the scrap piece of wood that i cut it from so maybe that will be easier.  

on this bronzed plexi....do you have a pic of that?  how does that work differently than lexan or clear plexi?
Navigation
Message Index
Next page
Previous page

Go to full version