| Main > Main Forum |
| "Neat" Control Panel idea |
| << < (3/3) |
| patrickl:
Well you could make em yourself but I spent 3 euro (about $4) on 6 12 terminals strips. I guess it wouldn't even be that easy to make em yourself. A barrier strip would probably be even easier to construct yourself. Basically a strip of wood and some screws. I'd use one screw to tie down 2 spade connectors, but then, for the cost of the spade connectors you should be able to purchase the terminal strips ... ::) So you could tie down bare wire, but you better make sure the barriers (between the terminals) are in place :P |
| Tailgunner:
Only down side to using terminal strips is it adds 2 (4 if you use terminals) more potential places for a circuit to break. |
| HaRuMaN:
I used barrier strips as well as spade plugs in my last stand alone controller. I tell you, it makes life a heck of a lot easier. Plus, it looks neat. :) My controller: http://www.arcadecontrols.org/yabbse/index.php?board=10;action=display;threadid=17483 |
| Navigation |
| Message Index |
| Previous page |