| Main > Main Forum |
| My serial LCD for displaying directions |
| << < (13/39) > >> |
| chrisindfw:
Thanks! That could be. I made my xml with my mame version. I emailed the sender on the instructions. |
| chrisindfw:
I am still waiting to hear back from the person who I got it from on how to power it. Does anyone who purchased one of these know how I can get power to this? If I had a camera id take pictures of the power connector. Its a 4 pin, 2 on top 2 on bottom. |
| maraxle:
It's the two pins on the left side of the four pin header. If you look at the board, you should be able to see the label that shows which one is ground and which one is power. |
| Aceldamor:
holding the screen face up and horizontal, the two pins on the left of the daughter board (where the db9 connector is) are the 5 volt lines. Top being current bottom being ground. If you hold the LDC Vertical with the contrast lever up they would be the two bottom pins, right side being ground, left side being current. |
| chrisindfw:
Thanks everyone for the help. I am still new to all of this and you guys make it easy. Is there a connector that I can get that easily attaches to one of the leads on the computer? I thought I have seen them here before. Additionally, is there a way to draw 5 volts from the IPAC? I am just trying to mount this on the control panel without having to run 15 different wires to the cabinet. Thanks again |
| Navigation |
| Message Index |
| Next page |
| Previous page |