| Main > Main Forum |
| X-Arcade controller not "clicking" |
| (1/2) > >> |
| MameMe:
I just received my x-arcade solo and I notice that I have to press extremely hard in the upwards direction to hear the "click". Therefore pressing up normally on the controller does not work, I have to really yank it up to get it to work. Is there something I could "adjust" inside the controller, for example move the UP-Switch closer to the controller shaft? ;D I said shaft. Serioualy though I could use some ideas here. |
| Nightmare03:
My joysticks are x-arcade replacements, when i used them as they was suppose to i also found i had to press up really hard to get a click, so i bent the pins on the microswitches so there closer to the center |
| MameMe:
Eww :-\ Hopefully it doesn't come to that, but I guess if thats the only way then that's what I'll have to do. |
| Zakk:
I think the instructions even say to open up the back and adjust the pins. There's a picture with the back open here: http://www.mameworld.net/massive/Cabinet/Project_X/project_x.html Just bend it with needle nosed pliers, there's only about 6 or eight little screws holding the bottom on. Good luck! |
| MameMe:
Well I bent the pins as suggested and although I'm not impressed with this solutions it does work. Thanks everyone |
| Navigation |
| Message Index |
| Next page |