Main > Main Forum
Rapid Fire Circuit
Ambrocade:
My fingers just can't take beating on buttons all the time. :(
I can work a soldering iron but unfortunately I don't understand gates and 555 timers and therefore don't know how to design a rapid fire circuit.
Anyone have a circuit design they would be willing to share?
It appears there used to be one on the Closet2Mame site but the link I have doesn't work.
Any help would be appreciated.
1UP:
Radio Shack has cheap little books with sample circuits for this purpose (usually made to flash LEDs etc).
Also try this site: http://webhome.idirect.com/~jadams/electronics/
I had a circuit I was going to use for my T2 guns before I got the recoil to work correctly. I'll post it if I come across it.
Dav:
I made one for a friend once, it was similar to this one that I just found in google.
http://www.westminster.org.uk/intranet/departments/electronics/555.htm#pins
I ran the output into a 4066 switch and spliced the 4066 into the line to the switch. Iirc I used 2 10k pots for r1,r2 and 100uf for c because I had them laying around.
I'm thinking about running off a few of them when I make my next order of circuit boards.
Dave
Druin:
I have also another circuit that can do rapid fire. It doesn't use the calculation-intensive 555 timer, and looks easier to handle.
http://members.rogers.com/druins22/arcade/
Click on the rapid fire link...it is just the oscillator to generate the pulses. To make it interface with the switches you'd do as someone else said, use it to control a 4066 chip. There is a 4066 circuit on this site as well, set up to show how to use one switch to control 3 switches at the same time...the rapid fire circuit can be hooked up to that. I can explain more if this circuit is going to be experimented with.
1-up:
I was thinking you could just use a simple resitor-capacitor LED flasher to do the trick. Add a push-on/push-off switch to toggle it, sub a pot for the resistor, and you'd have an adjustable turbo switch, no?