| Main > Main Forum |
| Which wood would a woodchuck MAME? |
| << < (3/4) > >> |
| hyiu:
whole cab including cp... 3/4 in brich plywood |
| bioart:
I used 5/8 particle board on most of it. Next one will be MDF (probably). I do like PB, but if you hit it too hard it will shatter easily :) |
| NoOne=NBA=:
3/4" plywood for the back part, and 1X poplar for the CP modules. I used solid wood for the CP part because I have a rounded front edge. Plywood doesn't work as well in that application. |
| Vol:
I'm using 3/4" plywood. I would have prefered to use 3/4" MDF but I can't find it at either Lowes or Home Depot around here. MDF is generally cheaper when compared to a plywood that will give you a similarly smooth surface. |
| Lilwolf:
if you go 3/4" MDF, your will save money on your T-molding (if you go that route). All other sized are 'special' I dont think plywood is as easy to cut the slot for the T-molding as MDF, but you get a LOT less sawdust. MDF is strong enough. So you don't have to worry about that. I went MDF and am happy with it. I didn't paint, (vynal) and I didn't have to sand before applying. If you go with a lexan top, I don't think it will matter at all. You might want to get the better grade plywood if you are going to put artwork between the lexan and CP. |
| Navigation |
| Message Index |
| Next page |
| Previous page |