| Main > Main Forum |
| $2 Bezel... |
| << < (6/18) > >> |
| Tailgunner:
The bottom cut to size and folded. |
| Tailgunner:
We need to mark the bottom pattern where the tube's curve is the widest, it's easy to pick out as there are a few extra pixels on the screen at this point. |
| Tailgunner:
I'm marking the centerpoint and where the corners are on the pattern. I want a border that's halfway between the phosphors on the screen and the edge of the tube. |
| Tailgunner:
I've cleaned up the corners with a compass to get a nice radius, and connected them to the center. I measured from the tube's edge to the phosphors at the center, divided that number in half to figure out where the center should be marked. I then drew the curve using an adjustable spline, but anything semi-flexable would work. You'll just need someone bend and hold it in place while you draw the curve. |
| Tailgunner:
The curve cut out, I'm checking it on the monitor to see if it need any adjustments. |
| Navigation |
| Message Index |
| Next page |
| Previous page |