Main > Main Forum
BEZELS, Bezels, bezels ... Anyone made their own ?
daeven:
A Happ bezel is designed to be trimmed to fit. I have a WG D9200 27" monitor mounted in a cabinet 27.5" wide. My bezel is trimmed to 26" wide. It could easily have been trimmed down to 25" if needed.
Trimming the bezel plastic is a matter of slicing it with a sharp utility knife along a straight edge.
joeblade:
Thanks for that info daeven, if thats the case, I will definately get a happs one then, as no doubst if I try to make one myself, I will make a mess of it.
I guess it doesn't matter too much, but was this information mentioned on their site, or was it a case of buy and try ?
Cheers
Tailgunner:
--- Quote from: joeblade on March 11, 2004, 06:53:14 pm ---Thanks for that info daeven, if thats the case, I will definately get a happs one then, as no doubst if I try to make one myself, I will make a mess of it.
I guess it doesn't matter too much, but was this information mentioned on their site, or was it a case of buy and try ?
Cheers
--- End quote ---
Concidering the cost + shipping of the Happs bezel, you could waste quite a few sheets of posterboard and still come out ahead.