| Main > Main Forum |
| - I-PAC2 v1.55c — WinIPAC Crashes on Config Push, Board Reboots |
| (1/1) |
| mark0804:
Hi all — hoping someone can help me crack this persistent issue with my I-PAC2 board running Multi-Mode firmware v1.55c. I’m trying to push a custom .ipc config using WinIPAC (installer version V2.1.41, executable shows 1.0.41.2). The board is confirmed to be in Keyboard Mode with Multi-Mode firmware active. All signal pins are disconnected except GND to avoid rogue mode triggers. Here’s the problem: * I load my .ipc config (all pins mapped to Gamepad buttons) * Click “Force Board Reconfiguration” * WinIPAC immediately shuts down or crashes * Board reboots into DInput or XInput Mode, but WinIPAC then reports “Keyboard Only Firmware” * I can’t push config again unless I reflash firmware and start overI’ve tried: * Reflashing firmware cleanly * Using minimal .ipc config (just Dpad + A/B + Start + Hotkey) * Disconnecting all inputs during push * Switching USB ports * Running WinIPAC as AdminStill no luck — config push crashes every time. I’m on Windows 11, and Batocera sees the board as “Microsoft X-Box 360 pad” when in XInput Mode, so the mode switch works — just not the config. Any ideas? Is there a more stable version of WinIPAC or a workaround to push config without crashing? Appreciate any help — this is the last hurdle in my arcade build. Thanks! —Mark (Perth, WA) |
| Navigation |
| Message Index |