Main > Main Forum

t-molding slot too big..how do I fit this molding?

<< < (2/2)

Crazy Cooter:

--- Quote from: RandyT on August 13, 2025, 11:24:47 pm ---...might be to cut some sections of tape of an appropriate thickness to give you a good bite, and wrap those small pieces over the spine every couple of inches to help keep it in place.  It might be cleaner and more reversible than the hot melt, which is difficult to make look uniform.

--- End quote ---

I'd do this.  Buy a roll of good masking tape from the local home improvement store and tape the T-molding spine down the whole length.  That should thicken up the spine and tighten everything up without becoming a permanent mess (glue).

SNAAKE:
yes hoping that does the trick. would hate to have multi colored molding on this thing..and I gotta go through the hassle of returning then

Navigation

[0] Message Index

[*] Previous page