Main > Main Forum

Ultimarc U360 flight stick in GRS Tron Stick Casing

(1/2) > >>

rgecko:
Hi,
I'm looking to take a u360 stick and replace the black casing with a Tron stick type casing.  Was thinking of taking a GRS Tron stick and use that casing on the U360.  I did find the old thread using a Happ stick and 360 but a happ stick is going for over 200 on happ, which i'd rather not spend.  any thoughts?

BlueGhost:
I bought one of each hoping to do the same thing.  I think the shaft on the GRS Tron Stick is larger, could have been the other way.  You would need to make or 3d print an adapter.  I also think one clamped around the shaft where the other bolted through it. 

Elmo2resc:
I had a Tron stick I bought used many years ago. Because I used it for more then just Tron I didn't like the way it played. The 360fs looked like a great solution to use it in multiple formats. I mounted the Tron handle to the 360fs with a adapter I made on my lathe. The Tron shaft is much larger. I needed to extend the wire a little bit but it works great. It isn't quite as firm as the original though.

Pic Attached

Jerome

rgecko:
That looks exactly like what I'm trying to do.  I took them apart, but cant find a way to get the tron stick to mount on the shaft of the u360 as BlueGhost mentioned with how it mounts. what does the adapter you made look like?  I wonder if I could 3D print something as I don't have access to a lathe.

Elmo2resc:
In the next couple of days I will be pulling it apart to add a stiffer spring. I will take a pic of it and post it.

Navigation

[0] Message Index

[#] Next page