Software Support > GroovyMAME
About to throw in the towel trying to crt emudriver to just work and need help.
Customcade:
Think the issue now is the arcade monitor was showing up under device manager as generic pnp monitor along with my dell pc monitor but now only the dell is showing up on device manager.
Zebidee:
--- Quote from: Customcade on December 12, 2024, 09:22:50 pm ---Screen is split vertically 3 times but stable with no shake.
--- End quote ---
This just means you are outputting video at >31khz frequency. That is the best a 15khz monitor can do, split the image so it can show onscreen. Earlier you probably selected the native 640x480 mode in OSD. This is hardwired into the video card (can't be removed) and in in progressive format (not interlaced).
Select the right desktop mode (custom) in OSD.
--- Quote ---Seems to be on the dim side overall too it use to be brighter.
--- End quote ---
Seems likely a normal consequence of having the image split three ways.
Customcade:
I think I tried native and custom and got the same results.
Can I use just the dell on the DVI output and set the osd for the dell it registers as shut it down and then plug in the 15k arcade monitor in its spot and it pick up fine or does the arcade monitor itself need to be registering in osd and VM maker.
As it sits now I can only get either program to see the dell and how I have it running by mdmi or dvi-I etc. But nothing about another monitor can be accessed aside a list of disabled in VM maker.
Customcade:
I don't remember what I had desktop res set to when I had it working with the arcade vga but ia it possible the wells k7600 just don't like 640×480 and need to go lower?
Customcade:
Also I am not using or have tried any legacy drivers of crt emudriver yet.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version