| Main > Project Announcements |
| car & home audio system on steroids 39" Dynamo Showcase cabinet project |
| << < (4/4) |
| Customcade:
Because that sub is going to be soooo angry more then likely I will cut out the side walls of some old automobile tires and cut them into square sheets to bolt to each the control panel base and the main cabinet base where they butt up and meet together so no vibration is getting to the main cab. Only thing in the control panel is wires soon that sub buttons cherri switch ipac4 trackball and spinner. Only concern is the trackball wanting to drift on its own from the subs power but may just line the inside of the control panel bottom with a thick layer or rubber also. Probably out of a solid one piece instead of car tire route if it's even a issue. |
| Customcade:
These are the armor I mean shielding plates I made out of bare metal shelve racks to be 1/4" Thick steel. I bolted these inside the monitor area of the cab right onto the outside wall of where all the mids and tweets would run along it. All my speakers are shielded stock mids and tweets and went the extra mile adding this in to ensure it don't mess with my screen color. Unshielded there is no way one could pull this off with a crt that close to that many. LCD your fine but this beast still rocks the 39" wells gardner k7600 😎 |
| Zeosstud:
That looks like a setup a fellow with a few friends could really enjoy. Cheers!! |
| Navigation |
| Message Index |
| Previous page |