Its there a way to use touchtunes hardware with windows?

Main > Audio/Jukebox/MP3 Forum

<< < (28/31) > >>

lilshawn:
not sure. i have had very few issues with any of the DI boxes... and if I do it's usually one of the power supplies. (+11v -11v rails)

there are some test points on the board in the middle of the main board. make sure you have voltages. if one is missing, that's the issue.

TP1 -11v - if missing replace U10
TP2 +12v - if missing check power connection at position C6 if missing, check R30 for open (zero ohm resistor, can be swapped for jumper)
TP3 +11 - if missing Replace U9
TP4 GND

abispac:

--- Quote from: lilshawn on September 03, 2024, 04:26:52 pm ---not sure. i have had very few issues with any of the DI boxes... and if I do it's usually one of the power supplies. (+11v -11v rails)

there are some test points on the board in the middle of the main board. make sure you have voltages. if one is missing, that's the issue.

TP1 -11v - if missing replace U10
TP2 +12v - if missing check power connection at position C6 if missing, check R30 for open (zero ohm resistor, can be swapped for jumper)
TP3 +11 - if missing Replace U9
TP4 GND

--- End quote ---
Im a bit sad, because I know you sent me this equalizer as an extra and they did sound great, but I ---fudgesicle--- the 2 of them already, not sure what I did, they both worked great for a few hours and nothing after I rebooted the PC. the inside looked ok nothing looks burned , and no burnt smell. Im not sure what I did, I want to fix them because the juke does sound better with them. I don't see tp1 or tp2,3,4 did you got confused and think ---fouled up beyond all recognition--- the red di box? cus those are working nice, its the equalizer boards that got damaged.

lilshawn:
right here :laugh2:

i'm not sure why they'd just stop working.

They do have a "direction", an input and output.

[computer] ----- [RED DI BOX] ----- [EQ IN - EQ OUT]----- [AMP]

I don't know if plugging them in backwards would do anything other than make it not output audio.

if all the voltages are good, there may be an issue with one of the OP-amp chips. (TL074C) not sure why that would be though. like i said... don't really encounter issues with these, as they are a pretty passive device and on the audio network they are designed for.

maybe be sure your network cables are "straight through" wired. (i'm a T-568B man myself) IE: make sure both ends are wired the same standard and not crossed over. you also need to have all 8 of the wires used. (Xbox'es used to come with cheap cables with only 4 wires (the bare minimum to connect) the boxes requires 3 left signals, 3 right signals and 2 power wires. (8 total)

abispac:
Tp3 is faling the thing is, what is it? hahaha,sorry I hate to be a pain in the ass, I regularly don't have problems finding most small components but this one does not come out with either 617-1054 or 617/1054. Can you please let me know what it is to see if I can find it locally please. Thanks for your patience.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version