Main > Main Forum

I-PAC 2 firmware upgrade issue

Pages: (1/1)

roy6585:

Hello, 

I'm hoping someone can advise me on how to correct my firmware upgrade issue. 


I have a post 2015 ipac 2 (I believe this to be a post 2015 because of the mini usb connector on bottom of board). It is currently on firmware 1.44. I would like to upgrade the firmware to multimode so I can switch the board to x-input. 


I have downloaded the firmware from the Ultimak site. When I run winpac2 and start the firmware upgrade, my board goes into resetting mode, then the secondary program pops up to select firmware , but my board is not detected again. Not sure why after resetting the board, it is no longer detected by my PC.

Any info would be greatly appreciated.


Thanks,

Roy 

Pages: (1/1)

Go to full version