Software Support > controls.dat

Ledblinky - How to ignore a led controller?

<< < (2/2)

Found a solution, it works so the coindoor stay lit when Hyperspin starts, good enough :)

1: Open LedblinkyAnimation Editor , go into file and select LED Controller Independant.
2: Create a  new animation with just the lights on for your coindoor and save it. I named it "Coindoor".
3: Open LedblinkyConfig.exe go into the Misc Options tab, enable cabinet leds, put in the type of controller and its ID on my case for a PacDrive it was PD1, under each tab below select the new animation you created above and save.

This will Light the coindoor each time you open Hyperspin as a separate animation."


[0] Message Index

[*] Previous page

Go to full version