Software Support > controls.dat

Ledblinky - How to ignore a led controller?

(1/2) > >>

Student123:
Hi,

I have 3 led controllers: Pac-Drive, IpacUltimate and another IpackUltimate. I have my coin door lights hooked up to my pac drive, used to run perfectly, but since I installed ledblinky it takes charge of all the controllers and it shuts it down.

Any way to ignore a controller or have lights on all the time regardless if hyperspin is running or not? Just want the Leds from that controller to light as soon as the pc starts.

Thank you!!

PL1:

--- Quote from: Student123 on December 22, 2023, 10:33:46 am ---Any way to ignore a controller or have lights on all the time regardless if hyperspin is running or not? Just want the Leds from that controller to light as soon as the pc starts.

--- End quote ---
If you want those lights to be always-on when the PC is on, remove the controller and power them directly from a drive power Molex connector.
- No animation = no need for a controller.   :cheers:


Scott

Student123:
Hi Scott,

Yes, thank you, the controller makes it easier to setup and maintain.

Much cleaner solution then using amolex directly to the lights.

Is there no alternative to have ledblinky bypass a controller or ignore it?

Thanks

PL1:

--- Quote from: Student123 on December 22, 2023, 01:20:52 pm ---the controller makes it easier to setup and maintain.

--- End quote ---
. . . except for the software . . .  :lol


--- Quote from: Student123 on December 22, 2023, 01:20:52 pm ---Much cleaner solution then using amolex directly to the lights.

--- End quote ---
Consider using a euro-style terminal strip for LED power distribution like mcseforsale did with his Blue Pill build.

http://forum.arcadecontrols.com/index.php/topic,117977.msg1266787.html#msg1266787






Scott

Student123:
Thanks, will look into it!

Navigation

[0] Message Index

[#] Next page