| Main > Project Announcements |
| Making PC Engine HuCards |
| << < (10/12) > >> |
| pdco_arcade:
Is there any reason could not add a contact in either of the the general areas depicted in the image? Is there anything in the PCEngine / TurboGrafx card slot / connector to made adding a contact a bad thing? |
| pbj:
Nope, shouldn't hurt a thing https://jt-studios.com/product/38pin-pc-engine-connector/ |
| lilshawn:
--- Quote from: pdco_arcade on January 09, 2024, 03:22:17 pm ---Is there any reason could not add a contact in either of the the general areas depicted in the image? Is there anything in the PCEngine / TurboGrafx card slot / connector to made adding a contact a bad thing? --- End quote --- i mean as long as you aren't using it as a solder pad that will increase thickness, as those 2 spots in particular, are within the "rails" that guide the card in. |
| pbj:
Maybe it’s time to play around with surface mount, but figured I may as well start using up these EPROMs I’ve been staring at for months. |
| pdco_arcade:
Those look really good. Especially the soldering. Almost looks like you know what you are doing. :-) Did you use a solid bottom sheet? |
| Navigation |
| Message Index |
| Next page |
| Previous page |